DSX-CHA004电缆RJ45通道认证模块

DSX-CHA004电缆RJ45通道认证模块，（邹先生1-3 7- 1 5- 29 - 75 1 0）DSX-CHA004通道与链路的区别，DSX-CHA004 Cable Adapter Fluke Networks！

自检：使用DSX-5000 CableAnalyzer验证DSX-PLA004和DSX-CHA004适配器

如果在测试时收到故障，则可能是DSX-PLA004链路适配器出现故障。如果您也在执行通道测试，那么您也可能有一个有故障的DSX-CHA004通道适配器。

 DSX-CHA004电缆RJ45通道认证模块

6类自检将有助于确定您是否有故障DSX-PLA004链路或DSX-CHA004通道适配器。

将DSX-5000 CableAnalyzer模块插入主机架。

接通主设备和远程设备的电源。

将DSX-PLA004链路适配器插入版本V/TFS主机上的DSX模块。（带液晶显示器的那个）

将一个DSX-CHA004通道适配器插入另一个DSX模块，并将适配器直接连接在一起，如下所示：

 DSX-CHA004电缆RJ45通道认证模块

Press the HOME button

Tap on the Test Limit field, which is the large rectangular area just below the PROJECT section.

Tap on NEW TEST in the lower left corner.

In the TEST SETUP screen, tap on the Test Limit: bar.

Tap on MORE in the lower right corner.

Select Application.

Swipe up to select Cat6 Selftest.

Tap on the Cable Type: bar.

Select Cat 6 F/UTP. (If you do not see this, tap MORE > Generic)

IMPORTANT: In the TEST SETUP screen, tap SAVE in the lower right corner:

按HOME按钮

轻触TestLimit字段，它是项目部分正下方的大矩形区域。

点击左下角的NEW TEST（新测试）。

在测试设置屏幕中，点击测试限制：栏。

点击右下角的“更多”。

选择应用程序。

向上滑动可选择Cat6自检。

轻敲电缆类型：巴。

选择6类F/UTP。（如果看不到，请点击“更多>常规”。）

重要提示：在“测试设置”屏幕中，单击右下角的“保存”：

Self test: DSX-PLA004 and DSX-CHA004 adapter verification with the DSX-5000 CableAnalyzer

If you receive failures when testing, there is the possibility of a faulty DSX-PLA004 Permanent Link Adapter. You could also have a faulty DSX-CHA004 Channel Adapter if you were carrying out Channel testing too.

A Cat 6 Self Test will help to determine if you have faulty DSX-PLA004 Permanent Link or DSX-CHA004 Channel Adapters.

Insert the DSX-5000 CableAnalyzer modules into the main frames.

Power up the main and remote units.

Plug in a DSX-PLA004 Permanent Link Adapter into the DSX module on the Versiv/TFS main unit. (The one with the LCD)

Plug in a DSX-CHA004 Channel Adapters into the other DSX module, and connect the adapters directly together as shown below: